Areas to which Fungicidal Solution is to be applied must be surface dry. Do not apply to exposed surfaces when rain is imminent or during frosty or windy weather.
On vertical surfaces apply by brush or coarse low pressure pneumatic spray (e.g. horticultural spray);air assisted sprays should NOT be used. Thoroughly work the material into the surface, particularly into any cracks, crevices or inscriptions.
On horizontal or sloping surfaces (e.g. paths, steps and roofs), Fungicidal Solution may also be applied using a watering can fitted with a fine rose.
The rate of application will be strongly dependent on the porosity of the surface and the amount of organic growth present at the time of treatment. On absorbent surfaces, such as cement render, concrete stone, and on surfaces heavily contaminated with growth, Fungicidal Solution should be applied at a rate of 1-2 sq.m /lit. On smooth, dense surfaces and previous paintwork where organic growth is light, rates of up to 4 sq.m/lit may be adequate.
While growth is very thick, two separate applications may be necessary. Remove growth killed by the first treatment after 7-10 days before applying second treatment.

Coverage                   - 1-4 sq.m/lit. depending on substrate conditions.
Appearance               - pale blue liquid.
Shelf life                    - More than two years
Storage                     - Store safely in a dry place and protect from frost away from direct                                   sunlight and foodstuffs.
Drying time                - Dependant on climatic conditions and nature of surface. Allow at least                                   48 hours before painting.
Cleaning                    - wash equipment in clean water after use.